I was slightly concerned that it wouldn't be loud enough. It's definitely a little quieter than my 1x12, but still loud enough for practice, and our amps get mic'd up at most NOSE gigs, so that isn't a concern. This means I can carry all my gear to a gig in one trip (guitar on my back, amp head over my shoulder, pedal board in one hand, cab in the other) which is helpful for walking from train stations to venues etc... I'm a little guy so the 1x12 ended up dragging on the floor a lot of the time.
For gigs where I'm not having to walk to the venue, though, it might be nice to have a bit more flexibility. All the cabs I own run at 8 ohms, and I'm aware that I can't run two of these in parallel.
As I understand it, I can plug one 16 ohm cab into the socket marked '16 ohms' or one 8 ohm cab into one of the sockets marked '8 ohms'. But in order to use the two '8 ohm' sockets in parallel, I have to be running two 16 ohm cabs.
The back of my 1x8 cab looks like this:
So could I have a speaker cable running from one of the '8 ohm' outs on the back of the Tiny Terror head, into one of these sockets, and then another cable running out of the other socket into my other cab. Would this be running two cabs in series?
