Ultra Fuzz and Power Drive gutshots

James · Post by **James** » Fri Sep 19, 2008 1:48 pm

I just made a post at a diy effects forum with these, and I thought I'd share hear for those interested. They were using SMD before it was cool. Behringer Ultra Fuzz on the way?

-----------

I might be selling this pair soon so I thought I'd get some pictures of the guts before I did.

Ultra Fuzz
Case Outer link
Case Inner link
Solder side in case link
Component side (whole board) link
Component side (top) link
Component side (bottom) link
Component side (angle) link
Pot leads rejoined link
Pot locations on the board (colour coded) link

Power Drive
Case Outer link
Case Inner link
Solder side in case link
Component side (whole board) link
Component side (top) link
Component side (bottom) link
Component side (angle) link
Pot locations on the board (colour coded) link

Excuse the cookery book, I didn't want to put it straight onto the patio but wanted to do it in natural light. The part labelled SW2 on the power drive (see the bottom component picture) is the switch, and the it fits inside the switch housing (see case inner picture).

Post by **Mike** » Fri Sep 19, 2008 1:52 pm

Very cool James.

More Cowbell · Post by **More Cowbell** » Fri Sep 19, 2008 2:24 pm

you making a clone james?

James · Post by **James** » Fri Sep 19, 2008 2:27 pm

Nah that's way too complex, especially when you consider how much you can buy one for.