Getting off top but I need to say how this works.DanHeron wrote:Thats a cool idea! Easy way to change the whole look of a guitar, i like.GEISHA wrote:The pickguards on those basses as well as on the Squire 51's are custom made.DanHeron wrote:Nice guitars man, and welcome. I'm also a noob here..![]()
I like the pickguards on the 2 basses (first column, 2nd and 3rd ones down), are they custom made?
That is I used adhesive foil, which can be bought at any DIY shop.
There are lots and lots of patterns, colours etc..
And if you don't like it anymore, rip it off and stick another one on it.
Cheap, relatively easy and it works.
Take the PG from the guitar and clean it.
Cut the foil in a size just a bit bigger as the PG itself.
Stick it on, easy, prevent bubbling.
If done take a towel and rub it firm on the PG.
Next take a very sharp hobby knife and slowly cut along the edges of the PG.
Take care not to cut into the PG.
For a laminated PG you need the knife to be applied under a certain angle.
Again easy does it, don't cut too much in the first take, but do it step by step.
I punch the screwholes with a sharp pin and press the foil in the cavity.
When screwing it down the foil will come nicely under the screw itself.
Try it.