rails on a mustang

matthoj · Post by **matthoj** » Sat Apr 17, 2010 6:07 pm

k.
reworking my mustang for a dimarzio super distortion in bridge, and a tone zone in the neck. my question is:
does anyone know a way to use the three way selector as a coil split? is this possible?

jagsonic · Post by **jagsonic** » Sat Apr 17, 2010 6:25 pm

I made it in my jagstang when i built in a seymour duncan jb. I found diagrams about on the SD webpage.

matthoj · Post by **matthoj** » Sat Apr 17, 2010 6:39 pm

we are trying so we can split each pickup... so we can retain original single coil mustang tones (well, somewhat) and then be able to have the dual humbuckers for heavy stuff...

Grant · Post by **Grant** » Sat Apr 17, 2010 7:38 pm

Found this somewhere on the SD forums a while back:

johnniespring · Post by **johnniespring** » Tue Apr 20, 2010 11:08 pm

what do you want each position of the switch to do? do you want it to be hum/off/sing? or something different?

matthoj · Post by **matthoj** » Wed Apr 21, 2010 10:26 pm

single/off/hum. tried the above diagram and didnt work with dimarzios. in the left position, both coils were active but real quiet. in the right position it was super loud. off position worked.