re-attaching stratocaster neck
Moderated By: mods
re-attaching stratocaster neck
Ok, so I switched the pickgaurd on my CV60's strat to a black one, and in the process I severed one of the volume pot connections . I did not realize my mistake until I had already restrung the guitar. Since I did not want to waste my new set of strings i detached the neck to gain access to the junk under the pickgaurd so I could solder the bad connection (without removing strings). I have reattached the neck and the neck is now bowed backwards to holy hell. I have diddled with the truss rod ever so slightly but I don't want to keep jamming away at it and destroy my guitar..
I rescrewed the neck on with a manual screwdriver and I definitely rushed it, I guess I figured that all 4 screws in tight = job well done. What can I do to correct this problem without bringing it to the shop?
I rescrewed the neck on with a manual screwdriver and I definitely rushed it, I guess I figured that all 4 screws in tight = job well done. What can I do to correct this problem without bringing it to the shop?
- taylornutt
- .
- Posts: 4908
- Joined: Thu Sep 17, 2009 5:04 pm
- Location: Dallas, TX
You could have unstrung it and still kept the strings...
Have you gone with a higher / lighter gauge set of strings ?
Have you lost or added a neck shim perhaps ?
Bridge lifted or dropped ?
Check for truss rod:
fret a string on the first and last fret and around the 9th you should have a little gap around the thickness of a credit card.
If it's any more or less/touching then a truss rod tweak is needed... otherwise and shim or bridge adjustment may be required.
Have you gone with a higher / lighter gauge set of strings ?
Have you lost or added a neck shim perhaps ?
Bridge lifted or dropped ?
Check for truss rod:
fret a string on the first and last fret and around the 9th you should have a little gap around the thickness of a credit card.
If it's any more or less/touching then a truss rod tweak is needed... otherwise and shim or bridge adjustment may be required.
rescrewing it with some elbow grease and pressure applied to the neck at the seam seemed to do the trick, must have been a bit of space between the neck and body. Now the action is higher than before, I suppose I can't expect a return to the perfect setup it had before... sigh.... Now I realize the tone control on the middle pickup has lost its connection too...GREAT! I knew changing the pickgaurd was going to be a pain in the ass, but not this big of one. Rage.
I gave it a quick once over by playing my Jag-stang close to the pickups- they all worked and the switch worked, but I guess I didn't pay enough attention to the tone of the middle pickup... A remote control would be an easy trickJoey wrote: remote control....
![Smile :)](./images/smilies/icon_smile.gif)
If I don't decide to go to take it to the shop, I will need to take it apart again sometime in the next few weeks when my GFS pots + switch + new cap. comes in the mail. I've been scouring the net trying to find a nice tutorial for rewiring a strat, but since I am a noob to soldering and what not the schematics still seem somewhat confusing and I'm sure one little mishap could ruin my plans. A tutorial would be nice.... are there any nude strat wiring diagrams that aren't just drawings?
This. Did the trick.Doog wrote:Sounds like either you haven't put the neck back in properly (hold it TIGHT against the pocket when screwing it back on) or you've misplaced a neck shim that was sitting in the pocket.
Doog you used to post over on Jag-stang.com didn't you? Is that you in yr avatar?