Jazzomaster New Build

Addam · Post by **Addam** » Tue Apr 12, 2011 10:12 pm

For the binding, just use a router bit made for the job. I got one off ebay, was about Â£20inc p&p from the usa. I haven't used mine yet though.

*edit*
This is where I got the bit from.

JohnnyTheBoy · Post by **JohnnyTheBoy** » Wed Apr 13, 2011 3:29 pm

AddamInsane wrote:For the binding, just use a router bit made for the job. I got one off ebay, was about Â£20inc p&p from the usa. I haven't used mine yet though.

Ahhh I wondered how it was done!...I tell u what, u have a go first and I'll see how hard it is ha ha!...then I might get one...make sure u stick it in a post for us all!...splendid stuff!...

JohnnyTheBoy · Post by **JohnnyTheBoy** » Fri May 06, 2011 1:44 am

Well i've been a busy bee making my own radius blocks and having a go at making my own custom trussrods....

Build pics....
http://www.shortscale.org/forum/viewtop ... highlight=

Ill post the trussrod build stuff after i've tacked it all together...just gotta get some more mig gas first

More logo fiddling as well!...mocked up to see what it will look like...

wwrrss · Post by **wwrrss** » Fri May 06, 2011 7:37 am

JohnnyTheBoy wrote:

I REALLY WANT THIS GUITAR!!!

JohnnyTheBoy · Post by **JohnnyTheBoy** » Tue Jul 05, 2011 2:09 am

Ok...been a while but i decided to give the Neck Radius Jig a go...

Holy Crap it works!!..just took my time and made several passes at varying heights...great result!

Then onto the neck radius...decided to use a two piece maple neck that i had decided to scrap...but!!!

That was more tricky..but it turned out better than i expected..i'll definitely have to finish it off with the radius block..
but again! great result from a homemade mdf trough...I'll have to attempt a skunk stripe for it next...

Then i'll have a go with the radius jig for the walnut fingerboard...fingers crossed...

Jazzomaster New Build

Re: Jazzomaster New Build