Recently acquired an extremely beat up Small Clone that has a bad case of old wiring (wires are literally crumbling off of it). I have a basic knowledge of soldering, however I'm still in my infant stages of reading schematics so I was wondering if anyone had a picture of the Small Clone's guts? Both sides of the board if possible! It would be a great help.
Anyone tried modding the SC?
Small Clone guts
Moderated By: mods
u did not state what yr or issue it was...so.... try this and I hope this will point u in the right direction
small clone info
the link in the 2nd post is pics and mods
you may have to set up a FSB.org account to fully see the gut shots in the 3rd post
small clone info
the link in the 2nd post is pics and mods
you may have to set up a FSB.org account to fully see the gut shots in the 3rd post
lorez wrote: I'm a fuzz lover so my clean is another man's crunch
Ahhh apologies! Basically I just want to get it back to it's original stock state for now. Since some of the wires have crumbled off I'm at a bit of a loss what needs soldered and where on the board. I'd eventually maybe like to mod it but for now I'd like to get it up and running firstSGJarrod wrote:u did not state what yr or issue it was...so.... try this and I hope this will point u in the right direction
small clone
Thanks for the link!I am assuming that just the wire coating is crumbling off, as I'm sure the the wire lead is copper or metal of some mixture.... I would just carefully change out one wire at a time or take detailed pics to reference when putting it back together.... just my 2 cents
lorez wrote: I'm a fuzz lover so my clean is another man's crunch
Just seen the updated post, exactly what I was looking for! Much appreciated!SGJarrod wrote:I am assuming that just the wire coating is crumbling off, as I'm sure the the wire lead is copper or metal of some mixture.... I would just carefully change out one wire at a time or take detailed pics to reference when putting it back together.... just my 2 cents