Page 54 of 215

Posted: Thu Dec 11, 2008 2:33 pm
by Reece
That yellow is so hawt.

Have you thought about doing simple 2 tone paintjobs? I think that yellow and the red you did jimmy's pedal in would amazing together.

Posted: Thu Dec 11, 2008 2:39 pm
by Mike
Yeah, Mezz's Green Ringer was two tone with a white stripe and metallic green. It wasn't the clearest edge on the stripe because I used masking tape, I think Electrical tape would be better in hindsight. I'll give it another go at some point - obviously it adds a spraying stage and a drying stages but it could be cool.

Image
Image

Posted: Thu Dec 11, 2008 2:42 pm
by Reece
Woah.

If I order another pedal I'm requesting some two tone goodness.

Posted: Thu Dec 11, 2008 4:25 pm
by Mike
Checkd on dots' case and annoyingly a small piece of newspaper had fallen on the case in the drying box from the protective covering, I've tidied it up and sprayed more coats of colour, but it means I'll probably not be able to lay decals until Saturday

Posted: Thu Dec 11, 2008 5:28 pm
by dots
best things come to those who wait! =]

Posted: Thu Dec 11, 2008 6:02 pm
by Mike
Let's hope so!

You cool with the following?

Face Decal Bottom Left.

"Modded Muff" text on the pedal.

Controls left to right, labeled: Sustain, Tone, Mids, Volume

and a toggle switch, possibly labelled something like "Diodes" which flips between Silicon Diodes and Red LEDs for different dirt sounds...

Posted: Thu Dec 11, 2008 6:13 pm
by dots
DEW EET

Posted: Thu Dec 11, 2008 6:15 pm
by Mike
Fierce.

Posted: Thu Dec 11, 2008 7:05 pm
by JaguarOW
hey mike would you be able to make a delay or flanger/phaser pedal

Posted: Thu Dec 11, 2008 8:43 pm
by Mike
I'm afraid both of those are too complex for me to do in a cost effective manner since I don't use PCBs. There are lots of great (and cheap) delay and phasers around though, check out the ones by Artec and Behringer for example.

Posted: Thu Dec 11, 2008 8:45 pm
by Haze
Mike wrote:Haze your pedal is done!

Image
is that a orange bottom i see??? awesome!

Posted: Thu Dec 11, 2008 8:46 pm
by Mike
Nah just a peek of what was there before, it's all Yellow pretty much, it's just a hint on that back face, the picture make it look more than it is

Posted: Thu Dec 11, 2008 9:01 pm
by JaguarOW
Mike wrote:I'm afraid both of those are too complex for me to do in a cost effective manner since I don't use PCBs. There are lots of great (and cheap) delay and phasers around though, check out the ones by Artec and Behringer for example.
thats fine just wondering

how much do you charge for pedals like benecols fuzzface?

Posted: Thu Dec 11, 2008 9:05 pm
by Mike
A Fuzzface with Fuller mods is $120 shipped if you're in the US, but if you're in the UK it's £70

Posted: Thu Dec 11, 2008 9:08 pm
by JaguarOW
ok i cant get it yet as im buying a new amp but ill probably be looking towards a new pedal in january

Posted: Thu Dec 11, 2008 9:10 pm
by Mike
No worries, if you fancy something just send me a pm or post in this thread.

Posted: Thu Dec 11, 2008 9:16 pm
by benecol
JaguarOW wrote:how much do you charge for pedals like benecols fuzzface?
I am the Trinny and Susannah of the pedal world and I claim my £5 - most sold pedal? Can you tell us a bit more about Dots's muff? Sounds interesting...

Posted: Thu Dec 11, 2008 9:23 pm
by Mike
benecol wrote:
JaguarOW wrote:how much do you charge for pedals like benecols fuzzface?
I am the Trinny and Susannah of the pedal world and I claim my £5 - most sold pedal? Can you tell us a bit more about Dots's muff? Sounds interesting...
haha.. you are my Pedal Svengali, you know what the people want (I haven't the foggiest!)

Dot's Muff
-----------
Green Big Muff circuit
Added Mids control (you tweak the tone stack slightly and replace a 20K resistor with a 25K pot (wired as a rheostat) and a 1K resistor to ground)
Toggle switch (DPDT) to flip between regular diodes (Si 1N4148's) and LEDs (Red) in the two clipping stages for different sounds.

I figure our fearless leader should have bells and whistles.

Posted: Thu Dec 11, 2008 9:27 pm
by benecol
Noice muff.

Posted: Thu Dec 11, 2008 9:30 pm
by Mike
Fit for the pages of the finest Jazz Mag.