Page 2 of 2
Posted: Tue Mar 23, 2010 10:28 pm
by Asher
hotrodperlmutter wrote:srsly. and he has tape over the control plate still? not even duct tape anymore, he downgraded to packing tape... gash.
i guess that's all well and good, but what's the point of the fucking screws?
It looks like he took it off after putting the wiring under the pickguard. He really likes tape though.
Posted: Tue Mar 23, 2010 10:57 pm
by hotrodperlmutter
like i said, he replaced the duct tape with packing tape.
so therefore, it's still on there after putting the wiring under the pg.
before:
after:
he even put the screw back in the hole he had the wires running through.
Posted: Tue Mar 23, 2010 11:05 pm
by Asher
Isn't this one the most recent picture? The wire's underneath and there's no tape on the control plate.
Posted: Tue Mar 23, 2010 11:22 pm
by Mages
Phil O'Keefe wrote:ac88 wrote:Is that thing just some add-on that tries to pull the mustang trem back into a fixed position? ^^
I have no idea of what is intention was, but that would be my guess. Either that, or to counter the internal springs to make it less sensitive.
yeah, but think about it, it doesn't counter the springs at all. think of the see-saw like motion of the stop bar posts. the stock springs pull the
bottom of the posts towards the neck, the gate hinge pulls the
top of the posts towards the butt of the guitar. so in the end they're both pulling the stop bar in the same direction, back against the strings.
Posted: Tue Mar 23, 2010 11:24 pm
by hotrodperlmutter
Asher wrote:Isn't this one the most recent picture? The wire's underneath and there's no tape on the control plate.
i dunno man, you've obviously got more time to spend on it than me. i'm going off the two pictures i saw (which is the longest i've ever spent on jagstang.com).
Posted: Wed Mar 24, 2010 1:54 am
by Phil O'Keefe
mage wrote:Phil O'Keefe wrote:ac88 wrote:Is that thing just some add-on that tries to pull the mustang trem back into a fixed position? ^^
I have no idea of what is intention was, but that would be my guess. Either that, or to counter the internal springs to make it less sensitive.
yeah, but think about it, it doesn't counter the springs at all. think of the see-saw like motion of the stop bar posts. the stock springs pull the
bottom of the posts towards the neck, the gate hinge pulls the
top of the posts towards the butt of the guitar. so in the end they're both pulling the stop bar in the same direction, back against the strings.
Hmm... you know, I do believe you're right! So basically, wouldn't this "mod" be similar to increasing the strength / tension of the internal springs, since it's pulling in the same direction (but from the opposite side)? IOW, it's something like adding two more springs to a 3 spring equipped Strat trem.