Posted: Fri Feb 18, 2011 1:36 am
mustang bars are too big for the hole
oh man that sounds really dirty!robroe wrote:mustang bars are too big for the hole
Page 2 of 2
Posted: Fri Feb 18, 2011 2:12 am
Posted: Fri Feb 18, 2011 4:19 am
I've actually never thought to try a vintage mustang trem arm. That might work, but the reissue ones certainly do not work.
Posted: Fri Feb 18, 2011 4:41 am
Anybody who owns both guitats with the tremolos willing to check that and maybe take a picture for us?
The Bronco Tremolo is very similiar to the Jaguar tremolo.
The Bronco Tremolo is very similiar to the Jaguar tremolo.
Posted: Fri Feb 18, 2011 6:36 pm
They are more different than I thought.
I had previously measured them with a crappy vernier at the arm section and assumed they were the same diameter.
The longer one is Mustang (well Jagstang, but they're the same)
Jagstang/mustang bar
Bronco bar
If i needed to I would buy the Mustang bar and run a 5mm drill down the retainer on the Bronco.
I had previously measured them with a crappy vernier at the arm section and assumed they were the same diameter.
The longer one is Mustang (well Jagstang, but they're the same)
Jagstang/mustang bar
Bronco bar
If i needed to I would buy the Mustang bar and run a 5mm drill down the retainer on the Bronco.
Posted: Fri Feb 18, 2011 7:02 pm
I was told that the usa mustangs were 3/18 across and would fit however the newer mij versions are 5mm ans so wont fit.
Posted: Fri Feb 18, 2011 7:08 pm
If that's a jag-stang bar then it's a reissue bar, we're talking about if a VINTAGE mustang trem bar would fit a bronco trem.AddamInsane wrote:They are more different than I thought.
I had previously measured them with a crappy vernier at the arm section and assumed they were the same diameter.
The longer one is Mustang (well Jagstang, but they're the same)
Jagstang/mustang bar
Bronco bar
If i needed to I would buy the Mustang bar and run a 5mm drill down the retainer on the Bronco.