Page 2 of 2
Posted: Sun Nov 13, 2011 2:23 am
by Pens
hotrodperlmutter wrote:did you ever get the mustang bridge and the neck plate homie?
Yes. I have not yet installed the stang bridge because I want to get some dowel rods and hammer a bit into the bridge hole, then drill out the exact size for the posts so it doesn't rock back and forth. I presently have it just wrapped with electrical tape but I wanna try something a bit firmer this time.
Thanks for sending those, dawg.
Posted: Sun Nov 13, 2011 2:56 am
by sp3k
I never had strings poping out after i chamged to 012 strings, and i like to play like a crazy person some times...
Posted: Sun Nov 13, 2011 3:16 am
by hotrodperlmutter
Pens wrote:hotrodperlmutter wrote:did you ever get the mustang bridge and the neck plate homie?
Yes. I have not yet installed the stang bridge because I want to get some dowel rods and hammer a bit into the bridge hole, then drill out the exact size for the posts so it doesn't rock back and forth. I presently have it just wrapped with electrical tape but I wanna try something a bit firmer this time.
Thanks for sending those, dawg.
np.
so you're not going to use the cups? are you going to secure it to the wood?
Posted: Sun Nov 13, 2011 3:16 am
by foll
word.
with mastery bridge one can go down to 09 without any problem.
sp3k wrote:I never had strings poping out after i chamged to 012 strings, and i like to play like a crazy person some times...
Posted: Sun Nov 13, 2011 3:17 am
by hotrodperlmutter
so you're saying offset is still down?
Posted: Sun Nov 13, 2011 3:42 am
by foll
lol
hotrodperlmutter wrote:so you're saying offset is still down?
Posted: Sun Nov 13, 2011 6:30 am
by Pens
hotrodperlmutter wrote:Pens wrote:hotrodperlmutter wrote:did you ever get the mustang bridge and the neck plate homie?
Yes. I have not yet installed the stang bridge because I want to get some dowel rods and hammer a bit into the bridge hole, then drill out the exact size for the posts so it doesn't rock back and forth. I presently have it just wrapped with electrical tape but I wanna try something a bit firmer this time.
Thanks for sending those, dawg.
np.
so you're not going to use the cups? are you going to secure it to the wood?
No, I have to leave the cups, that's where the grounding happens. I think. I was just going to jam a dowel down into the cup then drill out exactly sized holes for the bridge posts to go in.