Page 3 of 3
Posted: Tue Jul 29, 2008 8:55 pm
by Hurb
Mike wrote: Hurb's jazzer was shedding paint at Doogfest as I recall.
Nah it wasn't.
The paint that was really fresh was only like a little bit at the back that was a sand through.
Leave paint as long as possible. but at this time of year you are gonna need to wait less.
Posted: Tue Jul 29, 2008 10:26 pm
by NickD
Doog wrote:NickD wrote:
Doog- go for a cork sanding block for the flat areas, those soft ones make it very difficult to get even pressure.
What's the benefit of using a cork block over just a wooden block to wrap the sandpaper around?
Softer & less likely to rip the sandpaper and mark the body/new paint.
Wilkinsons is good for that kind of stuff, sandpaper, sanding blocks etc.
Posted: Wed Jul 30, 2008 8:03 am
by Mike
Do Wilkinson do Wet/Dry?
Apologise Hurb, I could have sworn you said it lost some paint.
I still lay clear on everything, it adds a visible layer of protection. My Baja Telecaster is blonde and has buttloads of clear on it, and I did the same with my Duo-Sonic body. In fact I've finished laying clear now and I'm just leaving it a month to cure before final buff and assembly.
Posted: Wed Jul 30, 2008 8:24 am
by Doog
I'll probably stick some clear on it, I'd rather make it as beefy as possible.
Posted: Wed Jul 30, 2008 11:25 am
by James
Mike wrote:Do Wilkinson do Wet/Dry?
They do but the grades don't got that high. I saw a pack I bought yesterday that was labelled 'fine', checked the back of a sheet and it was 400. I found some spare stuff from Halfords I'm gonna bring to doogfest. I think the grades were 800/1200/1500, something like that anyway.
Posted: Wed Jul 30, 2008 11:27 am
by Mike
1500 is what I'm using on the final sanding of my body. It's perfect for that, you just need a tickle.
Posted: Wed Jul 30, 2008 1:11 pm
by More Cowbell
You should defo do clear. YOu can use less paint that way, just make sure you get a nice even coat of colour, and then your done, just start doing layers of clear, then once they have hardened you can wetsand them down. USE BABY OIL for wetsanding.
Posted: Wed Jul 30, 2008 4:31 pm
by ludger
More Cowbell wrote: USE BABY OIL for wetsanding.
This is what I did and it worked fine for me. Wait, I used mineral oil...and I went up to 2000 grit. I found with 1500 grit it wasn't quite a mirror shine. The 2000 grit made it all better- some slight swirl marks/tiny scratches can be seen in the sun but it was a noticeable improvement from 1500.