Page 4 of 4
Posted: Thu Nov 11, 2010 7:40 pm
by ekwatts
theworkoffire wrote:hotrodperlmutter wrote:whatcha gonna use for pickups?
I have covers drawn up and ready to 3D print at Shapeways (
here) but I keep putting it off. Somedays I feel like you about it, some days I can't wait for the challenge... The covers will fit over Jag pickups with the claws hidden inside.
Have you used shapeways or a rapid prototyping service before? Depending on the colour of the plastic used you'll want to do a little bit of fine sanding when you get them if you decide to go through with it as the process leaves some small but distinct patterns.
Posted: Fri Nov 12, 2010 3:22 pm
by dezb1
theworkoffire wrote:
And at the risk of coming across like a self-satisfied knobhead, this one is pretty much my dream guitar:
nice, but what is it?
Posted: Fri Nov 12, 2010 3:42 pm
by theworkoffire
dezb1 wrote:nice, but what is it?
Homebrew
ekwatts wrote:Have you used shapeways...
Not yet, though I've done some no-hole Jag pickup covers for someone on offset via shapeways and he seemed pleased with them. It's worth a try - thanks for the tip, tho.
Posted: Fri Nov 12, 2010 4:02 pm
by dezb1
theworkoffire wrote:dezb1 wrote:nice, but what is it?
Homebrew
.
I like it even more having read that thread. really good work
Posted: Sat Nov 20, 2010 4:42 am
by robroe
puke oly white duo II
