Block Inlay
Posted: Thu May 31, 2007 9:52 pm
would anybody who has a jaguar with block inlay be willing to measure the dimensions of the blocks for me? it would save me a lot of trouble and make it more accurate. thanks.
Page 1 of 1
Posted: Thu May 31, 2007 10:02 pm
Don't they get smaller and smaller? That's a lot of measuring, dude.
Posted: Thu May 31, 2007 10:25 pm
yeah, i'm having a tough time getting the measurements down. i want them to look as close to the original ones as possible.
Posted: Thu May 31, 2007 11:33 pm
In inches? I don't have one but I thought I would specify.
Posted: Fri Jun 01, 2007 1:05 am
nevermind. i went ahead and cut some. it turned out ok:
they look a little rough around the edges, but that's just the plastic covering. they will not be going on this neck. sometime this summer, i'm gonna make one with a maple fretboard, black binding.
they look a little rough around the edges, but that's just the plastic covering. they will not be going on this neck. sometime this summer, i'm gonna make one with a maple fretboard, black binding.
Posted: Sat Jun 02, 2007 7:31 pm
for tracys tele i just found a good pic of a jaazzy with blocks and measured them on the page, there is a bit of an equation for transfering them to the neck, and then down the neck i want to say like 4.14 by the spasce within the fret area, will give you a raw dimension, but then again i don;t have my notes in front of me.