ShortScale.org

I just made a post at a diy effects forum with these, and I thought I'd share hear for those interested. They were using SMD before it was cool. Behringer Ultra Fuzz on the way?

-----------

I might be selling this pair soon so I thought I'd get some pictures of the guts before I did.

Ultra Fuzz
Case Outer link
Case Inner link
Solder side in case link
Component side (whole board) link
Component side (top) link
Component side (bottom) link
Component side (angle) link
Pot leads rejoined link
Pot locations on the board (colour coded) link

Power Drive
Case Outer link
Case Inner link
Solder side in case link
Component side (whole board) link
Component side (top) link
Component side (bottom) link
Component side (angle) link
Pot locations on the board (colour coded) link

Excuse the cookery book, I didn't want to put it straight onto the patio but wanted to do it in natural light. The part labelled SW2 on the power drive (see the bottom component picture) is the switch, and the it fits inside the switch housing (see case inner picture).

Very cool James.

you making a clone james?

Nah that's way too complex, especially when you consider how much you can buy one for.