ShortScale.org

Based on the classic 50 watt amps of the late 70's through the 80's, the Storm delivers all the kick ass rock tones you are looking for. More gain than the Vintage 50, by quite a bit. Amp is set up with 2 gain adjustments, and a push/pull pot for an additional gain boost. Can dial in a nice clean tone, to a killer crunch. Want old VH punch and crunch? Look no farther. Set up as a 2 channel amp, it has a low and a high channel. Can be set up to switch via the inputs, or a toggle switch, or if a person needs it footswitchable, thats possible as well.
As with all of our amps, it responds very well to the guitars volume control, and to your pick attack. No overly compressed, non dynamic mud. The Storm is very articulate, and touch sensitive.This amp is a non master volume amp, meaning it will not get you heavy preamp gain at whisper volume, it will require to be turned up a little bit.

Power section is 2 el34's, and the preamp uses 3 12ax7's. Solid state rectification keeps this amp tight, even when wound up.
Built with the same attention to detail, and high quality of all of our amps. Heyboer transformers, hand assembled and wired with ARS filter caps, "Dijon" coupling caps, NOS carbon comp resistors in all critical locations. Chassis are welded for extra support and durability, and switches are all heavy duty units for long troublefree service. I am constantly testing tubes for the best possible combination of tubes.

Standard on all amps is

Heyboer output transformer
Heyboer choke
Heyboer power transformer
Winged C or Mullard RI matched el34 power tubes.
A mix of Mullard, JJ, EI, or Tungsol preamp tubes.
NOS carbon comp resistors on plates and cathodes
"Dijon" mustard coupling caps
ARS and Sprague high quality filter caps
Handwired with silver core teflon jacketed wire.
External bias jacks, with top mounted 10 turn bias pot for easy,
precise biasing.