Page 1 of 1
How are your monitors hooked up?
Posted: Mon Feb 23, 2009 5:25 pm
by nomorebridge
I've just got my first Interface and I'm ready to get some monitors for it but the outs are only 1/4.... is this a problem is XLR any better and in which case should I get my hands on a small mixer?
Or if the monitors take 1/4 themselves does it makes absolutely no differnce at all?
How are all you people sorted?
Posted: Mon Feb 23, 2009 5:54 pm
by Al_
Do you know how the 1/4-in outputs are setup (e.g., TRS or TS connectors)? And will you be using powered or unpowered (with an external amp) monitors? I have three sets of monitors two are powered and one is unpowered. The powered monitors both have combo connectors (either XLR or 1/4 TRS). For the unpowered set, the amp takes 1/4-TRS inputs. The outputs from that amp to the speakers are on a barrier strip I think. At any rate, you should be able to use 1/4 in balanced cables (TRS) from your interface to an amp or monitors and be fine. Just take a look at the monitor or monitor/amp combo you'll be getting; but more than likely they'll accept 1/4-in connectors as well.
Posted: Wed Feb 25, 2009 1:54 am
by Ian
This piece of equipment improved my mixing by 190%
http://www.sweetwater.com/store/detail/MonitorStat/
Posted: Wed Mar 18, 2009 9:20 pm
by NBarnes21
Mine are hooked up by 1/4" balanced TRS cables, I'm pretty sure there's no real advantage to XLRs over these, but I could be wrong.
Posted: Thu Mar 19, 2009 10:30 am
by kim
ghetto
mini jack from macbook headphones out to rca on the back of my mini philips stereo.
