Current squier bullet strats

Noirie. · Post by **Noirie.** » Tue Jul 28, 2009 9:09 pm

So, as of late i've been thinking of getting one of these.
I know their not going to be great but have any shortscalers tried these? opinions please

Sloan · Post by **Sloan** » Tue Jul 28, 2009 9:19 pm

DO PANK!!!!

Will · Post by **Will** » Tue Jul 28, 2009 10:03 pm

My friend got one a few months back. Stock set-up was junk. I shimmed the neck, fixed action, tightened truss rod, tightened up the nuts and screws. After about 30 minutes of work, it was really very nice.

Fran · Post by **Fran** » Tue Jul 28, 2009 10:51 pm

I bought an Orange hardtail 1 x humbucker model last year. Everything was great except the neck, a bit flimsy. If you put any pressure on it the tuning would go flat or sharp depending on which way the pressure was applied. In the end fitted a 90s MIK Squier neck and it was awesome.

robroe · Post by **robroe** » Tue Jul 28, 2009 11:06 pm

i bought one last year. same model you posted there.

did a few mods to it

hotrodperlmutter · Post by **hotrodperlmutter** » Tue Jul 28, 2009 11:09 pm

neck was the biggest issues i saw when playing them. they're way too floppy. felt like plastic, almost.

would do pink with good squier neck and mint.

Ty · Post by Ty » Tue Jul 28, 2009 11:41 pm

robroe wrote:i

I really like how you set up the toggle in between the 2 knobs.

robroe · Post by **robroe** » Tue Jul 28, 2009 11:52 pm

its the same concept as a super sonic.

1 toggley
2 vol's
0 tonez

Fran · Post by **Fran** » Wed Jul 29, 2009 12:01 am

Thats Robs thang.

hotrodperlmutter · Post by **hotrodperlmutter** » Wed Jul 29, 2009 12:45 am

do not want robs thang. my epi dot studio has that config, and i hate it. i want to put the switch at the end. v > t > toggley

robroe · Post by **robroe** » Wed Jul 29, 2009 12:25 pm

how hard is it to get inside a dot?

i was trying to figure out mike stone's riviara and gave up

Noirie. · Post by **Noirie.** » Wed Jul 29, 2009 1:02 pm

robroe wrote:i bought one last year. same model you posted there.

did a few mods to it

Teh cuomo strat (wtf?)

tell me moar...

mezzio13 · Post by **mezzio13** » Wed Jul 29, 2009 1:11 pm

robroe wrote:how hard is it to get inside a dot?

i was trying to figure out mike stone's Riviera and gave up

Surgical tube on the pot shafts. Pre-wire everything and then thread the tube thru the holes. It gives you an handel to pull the stuff thru with, and is small enough to allow the nuts to slide over onto the threads, so you can hold them in place while tightening.

robroe · Post by **robroe** » Wed Jul 29, 2009 4:05 pm

Noirie. wrote:
robroe wrote:i bought one last year. same model you posted there.

did a few mods to it
Teh cuomo strat (wtf?)

tell me moar...

mez search for the build thread for this thing. SEARCH FUNCTION CHALLENGE FROM ON THE PHONE YESTERDAY!!!! im not even going to begin to try and find this shit.

mezzio13 · Post by **mezzio13** » Wed Jul 29, 2009 5:29 pm

robroe wrote:
Noirie. wrote:
robroe wrote:i bought one last year. same model you posted there.

did a few mods to it
Teh cuomo strat (wtf?)

tell me moar...

mez search for the build thread for this thing. SEARCH FUNCTION CHALLENGE FROM ON THE PHONE YESTERDAY!!!! im not even going to begin to try and find this shit.

I just got back from lunch (sleeping in the pargking lot down your street actually), or this would have ben sooner...

=W=

Noirie. · Post by **Noirie.** » Wed Jul 29, 2009 5:42 pm

Thanks. For sure i'm getting one of these, probably after doogfest though. Daphe with mop pickguard and black humbuckers would look sweet.

robroe · Post by **robroe** » Thu Jul 30, 2009 12:27 am

here i made you a fucking =w= demo

[youtube][/youtube]

robroe · Post by **robroe** » Thu Jul 30, 2009 4:47 pm

if that demo doesn't make someone want to buy a squier bullet nothing ever will. the fucking rock tones you get with it are epic