neck single coil with bridge hot rail pot ?'s
Posted: Sat Oct 31, 2009 5:04 am
i am completing my broncstang project in order to demo, and then send to ss.organite, thomas.
he was kind enough to provide me with a quote from fran which i've tried to follow closely;
if so, what should i do differently? would it be similar to wiring up anything with HS configuration, as in needing 500k in pots to keep the balance with the humbucker?
if not, thanks for your time.
he was kind enough to provide me with a quote from fran which i've tried to follow closely;
so i've got the pots, and the bridge hot rail. mo has been more than kind enough to donate a texas special single coil for the neck position. my only concern is that the 500k pots will be too much for the single coil. (seymour-duncan shows to wire a strat with singles/bridge rail with 250k pots.)Fran wrote:I used 500k mini alpha pots with a .047 orange drop capacitor, they work well with Hot rails and seem to take the excessive treble away that some Mustangs seem to have. The mini pots gave me more room in the control cavity, if i remember rightly its a tight fit with standard size pots but i may be wrong. Keep an eye on the shaft diameter as well, the pre-drilled holes on the control plate are small.
if so, what should i do differently? would it be similar to wiring up anything with HS configuration, as in needing 500k in pots to keep the balance with the humbucker?
if not, thanks for your time.