built a dod 250 clone. op amp changes?
Moderated By: mods
built a dod 250 clone. op amp changes?
i have used a 741 but i have socketed it, are there any others out there worth trying?
-
Bill Oakley
- .
- Posts: 334
- Joined: Sat Sep 26, 2009 6:16 am
- Location: Kennewick, WA
- Contact:
The NE5534P is low noise. I've been wanting to use an OPA604 in something but haven't yet so I don't know about them. Might have to check out the pin configuration on this one. Maybe a TL071.
I've found the 741 to be a bit noisy. You can pretty much use any single op-amp but just watch for pin configuration. Most are the same but some may not be.
I've found the 741 to be a bit noisy. You can pretty much use any single op-amp but just watch for pin configuration. Most are the same but some may not be.