ShortScale.org

SMALL UPDATE!
Ok, I think I've got the decal done. I'm going to have to nix a couple controls to keep it clean and to sell it at $180.


This is not the doe decal. Its the almost done decal.

We've got VOlume, (duh) Tone, (with a toggle to bypass the tone stack) Distortion (DUH) and feedback (with toggle to engage.)

The Baby Thundaa uses the same PCB as the ECT, but we have a few "fixed values"
We're leaving the Time Warp switch down, (Diode off) which is a slightly rounder more organic sound. So we're actually only clipping through 3 diodes rather than four in most muffy fuzzes. The "Trim" knob from the big unit will be replaced by a fixed resistor, much as it was in Hair Of The Dog.

March at the latest.

Hahah, that looks great, I'm sure you'll sell shit loads of them! There's a world of pedal board space hordering characters all over the internet. that being the internet, not the internet.

PHAT

SKINNY!

Damn! Was hoping on a timewarp switch and trim knob! That looks damn good, I'm sorely tempted. Any chance of a proto timewarp/trm version? Was there a poll somewhere about that?

Looks great man.


Gahhhh... do I need more dirt once I get my internet?.... gaaahhhhhh

aen wrote:SMALL UPDATE!
We're leaving the Time Warp switch down

I was ready to trade my ect for this one, but i need the time warp switch :/

The decal looks really nice btw

sucks that the 9V plug is at teh bottom.

am excite for demo though. i don't have enough room on my pedal board for ECT, so this might be just the ticket.

hotrodperlmutter wrote:sucks that the 9V plug is at teh bottom.

am excite for demo though. i don't have enough room on my pedal board for ECT, so this might be just the ticket.

It looks like it might fit in the top middle but its surprisingly cramped with 4 knobs and 2 switches up there. The 9v plug at the bottom takes the place of where a 9v battery would normally fit. Love that Dwarfcraft is battery clip free!