ShortScale.org

This weekend going to be racking in a fair amount of money and I will finally be able to afford to finish the custom guitar. Anyho, here was my plan with it:

- Neck pickup: Fender Tex-Mex
- Bridge: DiMarzio Tone Zone
- Neck switch: 3-way mustang, pickup selector
- Bridge: 3-way mustang, humbucker split
- Two concentric pots, one for each pickup, tone and vol

That's the basics of it. I'm hopeless though at drawing wiring diagrams and also don't know much about caps and resistors. If I had a diagram, I should be able to follow it. Can anyone help out?

Also I'm planning on replacing the singles in my modified Squier strat. ATM I have a copy JB in the bridge and standard squier singles in middle and neck. I want to try something interesting, any ideas?

seymourduncan.com has a whoooole load of schematics.

When you buy the Tone Zone it will come with a schematic that tells you how to wire it Series-Split-Parallel with a Mustang switch.

Ahh okay, checked the box and found it!

Anyho, still dont know what to do in regards to caps, what values should i get and in what way do you wire them?